I started by cutting a piece of paper at 14.5cm square and distressed the edges using scissors before adhering to my card blank.
I then chose a piece of paper with a focal image and cut this to 14cm square and again distressed the edges. I then tied a knot in a piece of the shabby ribbon in the set and adhered this in place - tucking the ends behind the paper for a neat finish. The top corner of this piece was curled forward and secured in place using a brad from the embellishment set. This panel was then adhered in place using foam pads for added dimension.
I added the half corner filigree to the top right corner along with a wooden cog. Additional texture was added on top of the ribbon using more wooden cogs toped with metal cogs coloured with gold wax so that they toned in with the whole vintage theme.
The words were cut from one of the bottom strips of the papers.
Finally I splattered embossing fluid around the card and added copper embossing powder to this before get setting in place.
No comments:
Post a Comment